SEAL Image 6500 Spécifications télécharger pdf (Page 6)

ENVIRONMENT CONDITIONS

The following environmental conditions are ideal for the best operation of the laminator.

AMBIENT TEMPERATURE

The best temperature for the SEAL

Image

6500 is

between 50°F and 86°F (16°C and 30°C).

Do not expose the laminator to direct sunlight as

output quality may be affected.

RELATIVE HUMIDITY

For best results, the ambient relative humidity for the

SEAL Image

6500 should be between 70-90% non-

condensing. Too much humidity will affect the prints

being laminated causing problems with film adhesion.

WATER AND MOISTURE

If the laminator is installed in a damp room or near

water, the electrical power supply must be in accordance

with the standards prevailing in the country concerned.

SURROUNDINGS

Install the laminator in surroundings that are as clean

and dust free as possible in order to obtain the highest

quality output.

The background dust level must not exceed that found

in a typical office/computer room environment.

The materials that are used on this laminator can have

an electrostatic charge and will attract dust, adversely

affecting the output.

POWER SUPPLY

Connect the laminator in accordance with the details

given on the identification plate attached to the rear of

the laminator. Refer also to the Technical Specifications

page for more information.

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Pas de commentaire

SEAL Image 6500 Spécifications Page 6