SEAL Image 6500 Spécifications télécharger pdf (Page 27)

MOUNTING

This process involves mounting previously prepared decals onto a substrate. No films or

adhesives are required for this process.

TO MOUNT DECALS ONTO A SUBSTRATE

• Place the mounting board on a flat surface.

• Lay your image face down on the mounting board

and expose approximately 1” (25 mm) of the

adhesive by peeling back the release liner along one

of the edges.

• Fold the release liner back making an even crease.

• Turn the image over and carefully position the

exposed adhesive edge of the image squarely onto

the board.

• Once positioned correctly, press the exposed

adhesive edge of the image firmly down onto the

board from the center toward the edges to ensure a

smooth surface. This is the edge that will be fed

into the rollers first.

IMPORTANT! Ensure that the Shim Wheel

settings of the rollers correspond to the board

thickness.

• Push the edge of the board into the rollers and

depress the foot switch until the board and image

are just caught by the nip.

• Flip the un-tacked portion of the image over the top

roller with one hand so that the release liner can be

peeled off the image with the other hand.

• Depress the foot switch to feed the board through

the rollers.

CAUTION! Because the foot switch overrides

the photo eye, be sure to keep your hands clear

of the rollers to prevent injury.

• At this point, continuous run can be selected by

pressing the Forward Motor Direction switch.

NOTE: Take care that the rollers do not grab

the liner.

• If the board is accidentally sent in too far at first,

the release liner will get caught and will be

impossible to pull back. In this case, stop and

reverse the motor until the liner can be pulled away.

• The image must be held against the roller while the

board feeds through to prevent wrinkles.

NOTE: Take care that the release liner does not

trip the optical safety system.

• As the process becomes more familiar, the speed of

the laminator may be increased to make the process

more efficient.

• Remove the mounted image from the rear of the

laminator, trim it to size and display it.

Figure 23. Mounting decals onto substrates

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

SEAL Image 6500 Spécifications Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Laminateurs SEAL Image 6500