SEAL Image 6500 Spécifications télécharger pdf (Page 7)

Accessories Included:

• 4 Foot Levelers

• 1/2” Wrench

• 3/16” Allen Wrench

• Grease Gun Kit

• Spare Fuses (Inside cabinet)

• Tape Measure

• Snitty

Safety Knife

• Image Roll Cleaner

• Terry Cloth Towel

• Spare Core for Wind-up Shafts

• Owner’s Manual

• Installation Instruction Sheet

UNPACKING, SET-UP AND INSTALLATION

Only skilled personnel should perform installation.

Read and comply with all warnings and follow the

proper installation procedures and safety

guidelines.

• Refer to outside of crate for Uncrating/Recrating

instructions.

• Take into account the weight of the laminator

(2260-lb./1025 kg net weight) when moving. Use

equipment with which the weight can be safely

lifted. The laminator is transported on a wooden

pallet (skid). If your laminator is still on its skid, you

can move it with a forklift to put it near its place of

use.

IMPORTANT! Set the forks of the forklift to

the maximum lifting width of the laminator, so

the laminator’s center of gravity is central

between the forks.

• NOTE: We recommend that you save the transport

bolts, nuts and plates of the shipping crate for any

major moves that you plan to make with the

laminator in the future.

• Remove the transport bolts from the skid’s

transport plates with a ½” open-end wrench or

adjustable wrench. Using the wrench on the bolt’s

flat, back the bolt up into the cabinet enough to

clear the cabinet castors for ease in moving.

• Your laminator has castors to allow for easy

moving. Roll the laminator to the location it will be

used. (See Workspace Area Diagram – Figure 2).

• Lock the castors once it is in place and remember to

unlock them before moving the laminator again.

Figure 3. Moving the laminator with a forklift

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

SEAL Image 6500 Spécifications Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Laminateurs SEAL Image 6500