SEAL Image 6500 Spécifications télécharger pdf (Page 35)

ERROR CODES

Error Messages In

Speed Display

Cause Solution

• One of the Emergency stop

push buttons is pressed

• There is no power to the Main

board

• Reset the Emergency stop pushbutton

• Check the Emergency Stop Buttons’ wiring

• Check the Fuses F7 or F8

• Rear Photo-eye is interrupted

• Remove the obstruction

• Adjust the Photo-eye sensor

• Front Photo-eye is interrupted

• Remove the obstruction

• Adjust the Photo-eye sensor

• One of the Auxiliary Stop

Switches has been pressed

• Check to see if something is pressing on the

switch

• Restart the

• Drive motor is in overload

• The motor is overloaded – Restart the

laminator by switching the laminator off at

the main switch

Error Messages In

Temperature Display

Cause Solution

No Display Lights

• No Power Supply • Check the Fuses F1, F2 and F3

Er 3

• The temperature does not

increase after the heater has been

switched on for 20 minutes

• Contact Technical Service

IMPORTANT! If any other error messages appear, contact Technical Service (see rear cover)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

SEAL Image 6500 Spécifications Page 35