SEAL Image 6500 Spécifications télécharger pdf (Page 13)

BACK CONTROL PANEL

1. Air Pressure Gauge: Indicates the PSI reading for the

downward pressure of the top pull roller. The

standard setting for the normal operation is 35-55

PSI.

2. Air Regulator Knob: Adjusts the downward pressure

of the top pull roller. Turn clockwise to increase the

pressure.

3. Roller Up/Down Switch (Rear, Top): Press the

switch up to raise the roller. Press the switch down

to lower the roller.

4. Reset Button: Press this button to reset the material

total usage counter to zero. Totalizer Display must

be showing to be able to zero out.

5. Ratemeter /Totalizer Button: Pressing this button

will toggle between the roller speed readout or total

material usage. Press this button to track and display

the total number of feet or meters run in a given

period, which can help to monitor film usage. The

total will be stored even after the laminator is turned

off, and adds to the total whenever the bottom main

roller is turning. The corresponding LED will be lit

when the totalizer is being used.

6. Ratemeter/Totalizer Readout: Displays the rate of

speed of the main rollers in either feet or meters per

minute, or displays the total number of feet or

meters run in a given period.

Figure 6. Back Control Panel

100

120

140

160

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Pas de commentaire

SEAL Image 6500 Spécifications Page 13