SEAL Image 6500 Spécifications télécharger pdf (Page 21)

AUTO-RUN / FOOTSWITCH OPERATION

AUTO-RUN OPERATION

• The continuos-run operation allows the user to set

the direction of the roller rotation and adjust the

roller speed by turning either of the Speed Control

knobs on the tops of the cabinets.

• This feature is useful for long runs that don’t

require much user control and when used in

combination with the roll easel shaft and wind-up

shafts can be efficient in an auto-run mode.

• Press the motor direction switch for the processing

direction desired.

• Turn the speed control knob on either of the Motor

Control Panels to adjust the speed of the rollers

(refer to the Top Motor Control Panel page).

IMPORTANT! If the photoelectric eyes

become blocked during continuous-run

operation, the roller rotation will stop

immediately.

IMPORTANT! Take care not to stop the motor

or block the photo eyes while an image is being

laminated as this can cause marks in the

output.

FOOTSWITCH OPERATION

• The function of the footswitch is to permit the

rotation of the rollers to be controlled in a hands-

free manner.

• This feature can be used when webbing materials

onto the laminator or feeding delicate images and

overrides the photoelectric safety eyes.

• Pressing the footswitch runs the laminator in the

direction that was pressed last (the active directional

switch will be illuminated).

• The rollers will run at the speed last set which is

indicated in the top display on either front or back

control panels.

• The speed can be adjusted when using the

footswitch by turning either speed control knob on

the top of the cabinets.

WARNING! While using the footswitch,

interrupting the photoelectric safety eyes does

NOT stop the laminator. An audible beep will

be heard, the motor directional switch will be

blinking and the roller speed will run in ‘slow

mode’ at a speed of 2ft/min (0.6 m/min.).

Releasing the foot switch will stop the

laminator.

• After clearing the photoelectric eye blockage the

buzzer will stop.

• To resume the pre-set speed, press the blinking

directional switch.

CHANGING FROM FOOTSWITCH OPERATION

TO AUTO-RUN MODE WITHOUT STOPPING

(to prevent stop marks on the substrate):

During footswitch operation (keep the foot switch

pressed), then press Motor Direction switch desired on

either Motor Control panel. The laminator will run at

the pre-set speed.

Next, release the foot switch.

NOTE: Do not stop the motor or block the photo

eyes while an image is being laminated as this can

cause marks in the output.

THE ROTATION OF THE ROLLERS WILL

STOP WHEN:

• The photoelectric eyes in the front or back of the

rollers are interrupted.

CAUTION! This does NOT happen when the

foot switch is used.

• An emergency stop button is pressed.

• An emergency tap switch is pressed.

• The stop button on the motor control panel is

pressed.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

SEAL Image 6500 Spécifications Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Laminateurs SEAL Image 6500