SEAL Image 6500 Spécifications télécharger pdf (Page 14)

CLUTCH CONTROL PANEL

Figure 7. Clutch Control Panel

• The Clutch Control Panel is located on the left side

cabinet when facing the rear of the laminator.

• The operator can adjust the amount of tension that

is directly applied to the laminate between the main

and pull rollers.

• The amount of tension applied affects the output

and extreme pull tension will stretch the hot films

causing outfeed waves in the finished product. This

is a factor with films such as Print Guard

, which

stretches easily.

• Excessive tension will also cause downward curl in

the finished product.

• The standard setting for normal operation is 40-60

PSI.

1. AIR PRESSURE GAUGE

Indicates the PSI reading for the pulling tension of the

bottom pull roller. The standard setting for normal

operation is 40-60 PSI.

2. AIR REGULATOR KNOB

This knob adjusts the pulling tension of the bottom pull

roller. Pull out the knob and turn to adjust; push back in

to set. Turn clockwise to increase the amount of pull

tension and turn counter-clockwise to decrease the

amount.

IMPORTANT! Excessive pull clutch tension will

cause premature wear to the drive system and may

cause damage to the laminator. Use the minimum

amount required for the laminating process.

100

120

140

160

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Pas de commentaire

SEAL Image 6500 Spécifications Page 14