SEAL Image 6500 Spécifications télécharger pdf (Page 4)

ELECTRICAL SPECIFICATIONS

Connect the laminator in accordance with the details

given on the identification plate attached to the rear of

the laminator. Refer also to the Technical Specifications

page for more information.

Single Phase Version:

(Part No. 60424)

For areas where the voltage requirements are

200-240V, the following is applicable:

Power cord:

3/6 AWG,

Type SOW-A/SO

Black Wire

White Wire

Earth Ground

Power Cord Strain Relief:

Turn clockwise to tighten.

IMPORTANT: The ground (green wire) should be

two inches longer than the black and white wires

to fit into the grounding lug.

Grounding Lug

90 C, 600 Volts

Figure 1. Wiring Diagram

CONNECTING YOUR LAMINATOR

All domestic laminators will be shipped without a power

cord. It is required that only a qualified electrician

provides power to the laminator or the warranty will be

void. We recommend a Ground Fault Interrupter (GFI)

circuit breaker with a 60-amp load rating, not exceeding

a 100-amp load rating. Use 3/6 AWG power cord, Type

SOW-A/SO rated to 90°

C and 600 Volts. See Figure 1

Wiring Diagram for detailed information. For European

laminators use a Residual Current Device

(RCD/RCCD). Once power is connected to your

laminator, press the Stand-by switch UP on the front

control panel to turn the laminator ON. If you have no

display, refer to the “Troubleshooting” page for

problem solving information.

WARNING! Any unauthorized changes or

modifications to this unit without our prior written

approval will void the user’s warranty and will

transfer health and safety obligations to the user.

IMPORTANT! SEAL Graphics recommends that a

licensed electrician in accordance with electrical

codes in your area install your mains power.

Specifications subject to change without notice.

IMPORTANT! The mains outlet should be fused

no higher than 60 Amp, Three-phase -or- 100 Amp,

Single phase.

1 2 3 4 5 6 7 8 9 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

SEAL Image 6500 Spécifications Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Laminateurs SEAL Image 6500