SEAL Image 6500 Spécifications télécharger pdf (Page 32)

CLEANING / MAINTAINING YOUR LAMINATOR

WARNING! Turn the door interlock to the

OFF Position and then disconnect the

laminator from the power supply before

cleaning or greasing the bearings.

CLEANING THE LAMINATOR

• The laminator may be cleaned with a lint-free cloth,

lightly dampened with a mild soap and water

solution. Do not use spray-on cleaners. Do not

immerse any part of the laminator in water or other

liquids.

• Do not use an abrasive cleaner, which can damage

the painted surfaces.

• Do not allow water or liquids to enter the electrical

circuits, which may cause personal injury and/or

damage the equipment when power is applied.

GREASING THE BEARINGS

• You must grease the top and bottom roller bearings

once each month or every 200 hours. Refer to the

Grease Gun Kit included in your accessory kit for

supplies and instructions.

WARNING! Failure to lube bearings will cause

premature wear, which may cause costly repairs

and will void your warranty.

Call Technical Service for further assistance (see

rear cover).

CLEANING THE ROLLERS

IMPORTANT: Clean the laminating rollers

every day to prevent adhesive build-up and to

ensure quality output. Adhesive build up may

eventually damage the rollers.

• When laminating, a small amount of adhesive will

squeeze out between the laminate films and onto

the top and bottom rollers. This residue

accumulates through normal use and can be easily

cleaned off the rollers.

• Use the Image roll-cleaner (included) to remove the

excess adhesive from the rollers. This is best done

with the rollers hot.

WARNING! Use only an Image Roll Cleaner or

a cotton cloth and Isopropyl Alcohol (IPA) to

clean the rollers. Do not use other solvents or

cleaners. Use of other cleaners or solvents may

cause roller damage and will void the warranty.

• When cleaning the upper roller, place a piece of

scrap foam board under the roller to prevent the

removed adhesive remnants from falling onto the

lower roller.

• For adhesive that is difficult to remove, allow the

rollers to cool and use isopropyl alcohol (IPA) and a

clean, lint-free cloth. Never pour isopropyl alcohol

(IPA) directly onto the unit.

CAUTION! Always use care when using

Isopropyl Alcohol (IPA)! IPA is very flammable.

The flash point of IPA is 51.8°F (11°C). The

self-ignition temperature is 752°F (400°C). Wear

rubber gloves and use in a well-ventilated area.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Commentaires sur ces manuels

Pas de commentaire

SEAL Image 6500 Spécifications Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Laminateurs SEAL Image 6500