SEAL Image 600-C Guide de dépannage télécharger pdf (Page 13)

SET-UP AND OPERATION

HOW TO SET THE SHIM WHEELS

• First, determine the thickness of the board that you

will use for mounting.

• You must first raise the top roller and then press

down and turn both the shim wheels until the

desired measurement corresponds with the

thickness of board being used.

• Lower the top roller once the shim wheels are

adjusted.

WARNING! Too much pressure can crush the

board being used and even damage the top and

bottom rollers. Normally, a press of .025”

(0.6mm) is sufficient.

Figure 5. Shim Wheel Adjustment

SHIM WHEEL SETTINGS

Whenever you mount onto a board, etc., it is important

to adjust the rollers to create a gap nearly equal to the

thickness of the board being used. This is done so that

anything passing between the rollers will receive the

right amount of pressure.

Equivalent Press Measurements

Inches Metric (mm) Decimal

1 25 mm 1.000

3/4 19 mm 0.75

1/2 13 mm 0.50

3/8 10 mm 0.375

1/4 6 mm 0.25

3/16 5 mm 0.1825

1/8 3 mm 0.125

1/16 2 mm 0.0625

-1/16 -2 mm -0.0625

0 0 0

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Pas de commentaire

SEAL Image 600-C Guide de dépannage Page 13