SEAL Laminator SM110EN Manuel d'utilisateur télécharger pdf (Page 34)

Adjustment Procedures

5-7 Image Guide

To perform the following adjustment, it is necessary to remove both plastic side covers first. See

Section 4-1: Disassembly/Reassembly Plasic Side Covers.

Necessary tools: allen key 3mm, gauge 2mm.

The distance between the upper edge of the Image Guide and the roll surface must be 2±0.5mm

(0.0787±0.0196 inch), see figure 37.

1. To adjust the Image Guide, it is

necessary to position it in front of the

top roller, onto the two support

brackets (see arrow #1).

2. Slide the Image Guide all the way

towards the roll; make sure that the

front edge of the Guide is under the

bolt mounted in the support bracket

(see arrow #2).

3. If necessary, loosen the two socket

screws (arrows #3), that hold the

support bracket, half a turn. Perform

this at either side of the machine.

4. Reposition the support brackets until

the previously mentioned distance of

2 mm has been achieved.

Thighten the socket screws and

reassemble the plastic covers.

fig. 37

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 48 49

Pas de commentaire

SEAL Laminator SM110EN Manuel d'utilisateur Page 34