SEAL 6500 Manuel d'utilisateur télécharger pdf (Page 16)

CHECKING OPERATION

After you are familiar with the control panels and

their functions, check all operations.

Check the Main Power

• Press the Stand-By switch up and the front and back

displays on the control panels should be lit.

• The center red switch on both top cabinet control panels

should be illuminated.

Check the Emergency Stop Buttons

• Press one of the Emergency Stop buttons and the

laminator will shut down.

• Rotate the Emergency Stop button clockwise to reset.

• Repeat this procedure with all four Emergency Stop

buttons.

Check the Heater Controls

• Press the top heater On/Off button once; the corre-

sponding LED should be lit.

• The readout will display the ambient temperature.

• Press and hold the top heater Up arrow to increase the

temperature set point. Watch the readout for 5 minutes

to verify that the temperature increases.

• Press and hold the Down arrow to decrease the tempera-

ture set point.

• Press the top heater On/Off button again once; the

corresponding LED should not be lit.

• Repeat this procedure for the bottom heater.

Check the Motor and Foot Switches

Check both motor control panels as follows:

• Push the green Motor Forward switch and the rollers

should rotate in the forward direction.

• Press the green Motor Reverse switch and the rollers

should rotate in the reverse direction.

• As you turn the Speed Control knob clockwise the speed

of the rollers should increase and the speed readout (top

display on front and rear control panels) should increase

in number.

• Turning the Speed Control knob counter-clockwise

should decrease the speed of the rollers and the speed

readouts should decrease in number.

• Press the center red Motor Stop switch and the rollers

should stop rotating.

• Press the foot switch and the rollers should rotate in

whichever roller direction that was last pressed. Check

both foot switches for operation.

CHECKING THE ROLLERS

Your laminator has a pneumatic pressure adjustment with

fine-tune control for a smooth, flat finish. Correct adjust-

ment of the pressure rollers’ height is essential for safe and

proper operation. Check this prior to every use.

Check the vertical movement of the top rollers as

follows:

• Press the roller switch UP. The top roller should rise

smoothly and evenly on both ends.

• Press the roller switch DOWN. The top roller should

lower smoothly and evenly on both ends.

• Repeat this procedure for both front and back top

rollers.

IMPORTANT! The silicone covering of the rollers is

soft. Do not scratch the surface with a sharp object or

fingernail.

WARNING! If your laminator does not operate cor-

rectly, contact Technical Service immediately.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

SEAL 6500 Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Laminateurs SEAL 6500